| |
Jonathan Wilson wrote:
>
> > They do line up, but not absoluteley perfectly. As I recall when playing
> > with them, the slopes are a little different, though I don't remember
> > exactly what the difference was.
>
> Good. Then I Can use the ldraw part of the panel to mock-up the door frame
> for my aquazone mega model.
Of course you may want to do a little bit of work. The door frame is 2
studs deep instead of the pannel's 6 studs wide. The frame is also about
1 brick thick instead of being rod thickness. But yes, not knowing much
about ldraw, I would say that it should be pretty easy to create a
mockup using the panel.
I think the vertical portion of the frame is also 2 studs wide. I seem
to remember that the panel fits closer to the middle of the frame,
rather than being flush with it (when you combine 2 frames and 2 panels
to make an archway). Note that the frame has hinges on both sides so
there is only one frame piece, not a left and right.
--
Frank Filz
-----------------------------
Work: mailto:ffilz@us.ibm.com (business only please)
Home: mailto:ffilz@mindspring.com
|
|
Message is in Reply To:
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
