 | | Microscale truss bridge —Jacob Sparre Andersen
| | | | Couldn't resist the bricks this morning: (URL) Play well, Jacob -- (URL) Red Bird Mark II> (14 years ago, 6-Oct-10, to lugnet.announce.moc, lugnet.build.microscale, lugnet.town, FTX) !
| | | | | | | | | | Re: Microscale truss bridge —Ross Crawford
| | | | | (...) Nice! Would it look better with a 1x10 for the top & bottom beams instead of 1x4s? ROSCO (14 years ago, 7-Oct-10, to lugnet.build.microscale, lugnet.town, FTX)
| | | | | | | | | | | | Re: Microscale truss bridge —Jacob Sparre Andersen
| | | | | | (...) For this length, I think it might look better with 1x10 plate for the top beam, and dropping the 1x4 plates on the bottom completely, leaving the bridge deck to form the bottom beam. - But then I wouldn't be able to reuse the design for a (...) (14 years ago, 12-Oct-10, to lugnet.build.microscale, lugnet.town, FTX)
| | | | | | | | | | | | | Re: Microscale truss bridge —Jacob Sparre Andersen
| | | | | (...) You might say that it looks better that way: (URL) Play well, Jacob -- (URL) Jacob's LEGO> (14 years ago, 18-Oct-10, to lugnet.build.microscale, lugnet.town, FTX)
| | | | | | | | | | | | Re: Microscale truss bridge —Ross Crawford
| | | | | (...) Indeed I might 8?) If you need to extend it, you can just butt plates end to end along the top without joining them and it would probably look OK. ROSCO (14 years ago, 19-Oct-10, to lugnet.build.microscale, lugnet.town, FTX)
| | | | | | |
