 | | Re: new program to aid part making: ldraw circle creator
|
|
I have to agree here. Some of your messages are kind of(sometimes very) confusing. And when you reply to a message you delete what was in the message rather than leaving the part of the original message you were replying to. If you were to do that, (...) (28 years ago, 8-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
 | | Re: new program to aid part making: ldraw circle creator
|
|
(...) Could you set your line length to less than 80? The whole sentence above that starts with "I have to" is one huge long line. (28 years ago, 8-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
 | | Traffic page link
|
|
Todd, would it be practical to hook up a link to the traffic page near/at the top of the browse lugnet.com/news/groups/groups page? That might make browsing a bit more flexible. -Tom McD. remove the spamcake. (28 years ago, 8-Apr-99, to lugnet.admin.general)
|
| |
 | | Re: Lugnet.cad.dat heirarchy
|
|
I agree, and I think cad.dat serves very well for MOC's. -John Van jonathan wilson wrote in message ... (...) (28 years ago, 8-Apr-99, to lugnet.admin.general, lugnet.cad.dev)
|
| |
 | | Incorrect LUGNET Link
|
|
I was browsing through the plan you keep referring to: (URL) page makes reference to the Minifig Generator but points to good old (URL) when it should be (URL) a little time to find that - if I didn't remember baseplate.com I never would have found (...) (28 years ago, 8-Apr-99, to lugnet.admin.general)
|