 | | Re: ME Models Metal Rails
|
|
(...) I'm not sure if I fully understand your question here, but I do have the additional geometry available for use in track draw, meaning, I should be able to convert it to BlueBrick (but I haven't played with it much). (...) I should be able to (...) (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) when using CAD based track designers like Bluebrick? The full, half and quarter lengths of both the straight and curved tracks? Does the future also include renditions of the switches are crossings? (13 years ago, 3-Apr-11, to lugnet.trains)
|
| |
| | Re: Number of packages in set 10185
|
|
(...) Check out the set contents at the link below. It appears that your contents match the number of bag in the photos. (URL) (13 years ago, 3-Apr-11, to lugnet.general)
|
| |
| | Re: ME Models Metal Rails
|
|
(...) I have a sample and the edges, while crisp rather than rounded, are not sharp enough to cut. There may be a bit more wear due to the metal corner, not sure. But I'm not too worried about that. The adapter piece is a little less shiny than (...) (13 years ago, 2-Apr-11, to lugnet.trains)
|
| |
| | Number of packages in set 10185
|
|
I have set 10185 Green Grocer, but it is opened. There is 8 packages with the #1 on them there is 5 packages with the #2 on them and 10 packages with the #3. There is one with no number, also two green plates and three instruction. Is this correct? (...) (13 years ago, 2-Apr-11, to lugnet.general)
|
