 | | Re: SR 3D Builder 0.5.1.3
|
|
--snip -- (...) --snip-- (...) While I must confess to never using your program (for various reasons good and bad) if you want any help with flexible parts it's something I can probably be of assistance with. I've written a few academic papers on (...) (14 years ago, 19-May-10, to lugnet.cad)
|
| |
| | Re: Toy Story Train comments?
|
|
(...) Technically this engine has very ordinary articulation. The "driver" bogey uses a standard 4x6 bogey plate, and the front bogey is still attached with a centered pin even if it's a bit higher than normal. As for how it runs, another member of (...) (14 years ago, 19-May-10, to lugnet.trains)
|
| |
| | Looking for LDraw file and/or instructions
|
|
Hi all, Can anyone point me to or send me the LDraw file and/or instructions for this building: (URL) does anyone recognize it or knows who designed it? I think it was rather famous back then? Thanks. Jaco (14 years ago, 19-May-10, to lugnet.cad)
|
| |
| | Re: SR 3D Builder 0.5.1.3
|
|
(...) This is my roadmap: - Fix bugs in hinges movements (there are a lot) - Add support for flexible parts - Add support for pistons - Add interface for animations management - Physics animation recognition based on predefined schema. To be (...) (14 years ago, 19-May-10, to lugnet.cad)
|
| |
| | Re: Toy Story Train comments?
|
|
(...) I always respected your profound dislike of the blays, though I never quite understood why it upset you so much, Ben. But such is life:-) I just miss the good old days when you and I and all of the other old-timers were a lot more vocal on (...) (14 years ago, 19-May-10, to lugnet.trains, FTX)
|
