 | | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) I agree: the input side is connected to the orbiter; the output shaft connects only to the cog. That is exactly the way mine is built. Where I disagree with the LDRAW file is the nature of the liftarm: what is shown is a 1x5 liftarm with only (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Zero Hour on Highway 44
|
|
(...) 'Enjoy' is too mild a word, guys. I have not yet managed to pick my jaw up off the floor. Un-bleeping-believable! There are so many gems in this monster that just mentioning any particular set of features seems like faint praise, but I really (...) (16 years ago, 23-Mar-09, to lugnet.build.mecha, FTX)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Only the input side of the orbiter is connected to a shaft (via 1x4 liftarm) the output shaft turns freely (via 1x5 liftarm) inside the orbiter and connects to the Cog Only. It should be as shown here: (URL) dont have Ldraw installed on this (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: NXT based 3D scanner
|
|
Hi Eric, (...) Sorry for the aspirin, that was not intended ;o) (...) Thanks! And yes, I am from Earth... Philo (16 years ago, 23-Mar-09, to lugnet.cad, lugnet.robotics)
|
| |
| | Re: new mocs: doorway studies 5-8
|
|
(...) As always, your designs are wonderful, Deborah! I particularly like the baronial doorway. Very clever use of elements, like the rock halves as planters and the just-barely fanned out elements in the transom. What parts are you using to get the (...) (16 years ago, 23-Mar-09, to lugnet.build.arch, FTX)
|
