|
|
 | | Re: NXC: turning on the light
|
| (...) Since the lamp is a rather power hungry device, it is best to drive it with an output port. Use OnFwd(port, pwr) to turn it on (with brightness controlled by pwr parameter), Off(port) to turn it off. Though I have not tested, it should also (...) (16 years ago, 15-Apr-08, to lugnet.robotics)
| | | | | Re: NXC: turning on the light
|
| (...) The lamp is relatively power hungry, so you should connect it to a motor port for best result. OnFwd ("ports", "pwr"); will light it, with brightness controlled by the pwr parameter. Off ("ports"); will turn it off. I have not tested, but most (...) (16 years ago, 15-Apr-08, to lugnet.robotics)
| | | | | Re: Dragonwolf
|
| (...) Thanks, Fradel. Good call on the Zoids influence- it shows particularly with dorsal turret. I have that wind-up wolf Zoid, btw. Later, Todd (16 years ago, 15-Apr-08, to lugnet.build.mecha)
| | | | | Re: NXC: turning on the light
|
| Thanks a bunch for the reply! The education set has the lamp, so my students would like to use it now... I'll keep you 'posted' about the results... Regards, Torsten Otto (...) (16 years ago, 15-Apr-08, to lugnet.robotics)
| | | | | Re: Dragonwolf
|
| (...) AWOOOOOO! Welcome back to Mecha. It has been a long time indeed. I was perusing Brickshelf before I even saw this and instantly recognized it as yours. I was like, "grey mecha with a touch of blue, oh snap thats my homeslice A-T-A!" I have (...) (16 years ago, 15-Apr-08, to lugnet.build.mecha)
|
|
