|
|
 | | Re: New Parts Drawings - Plates, Slope, Track Pieces
|
| (...) Are you doing 3rd angle projection or 3D? 10 minutes is a lot less than it took me in Paint. I suppose once you're trained in AutoCAD, a lot of things are quick. Could you post jpegs of the results? I created bits like studs in the drawing and (...) (21 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
| | | | | Re: New Parts Drawings - Plates, Slope, Track Pieces
|
| (...) Thanks, I like to do a proper job :-) (...) Up to now, there is no plate to go with the 4x4 round brick and the half cylinders. This means that unless your round bricks have exactly 4 bricks between them, you can't support them at the side (...) (21 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
| | | | | Re: A present for my Dad and a 6 wide tank car.
|
| (...) Yes the ARR version is idenical to the BNSF set. Although there were some small changes do to part availability. Like the hood is not availible in blue. The Raised part behind the cab, I substituted for other slope parts to get the same (...) (21 years ago, 4-Feb-05, to lugnet.trains)
| | | | | Spinwheel revised
|
| Hello! After I got some parts from Great Britain (Thanks!) I was able to re-build the old spinwheel in brown. While I was at it I eliminated all non-LEGO parts and rearranged it a bit. (URL) me, I'm a link!>> The old one was this: (URL) spinwheel>. (...) (21 years ago, 4-Feb-05, to lugnet.announce.moc, lugnet.build, lugnet.castle, FTX) !
| | | | | Re: New Parts Drawings - Plates, Slope, Track Pieces
|
| (...) OK, so the piece is like this: 1. The base is 3x3. 2. Is the corner a right angle, an 8mm radius curve, or a 16mm radius curve, like this piece? (URL) 3. I assume it has 2x2 studs on top, as if two 2x3s with curved top had been superimposed at (...) (21 years ago, 4-Feb-05, to lugnet.parts.custom, FTX)
|
|
