 | | Re: Robolab Documentation
|
|
(...) based on a question that I asked back on Dec 11: "I followed instructions replacing firmware.txt with the replacement file as instructed. The download went smoothly,immediately upon finishing (two beeps) the LCD screen started counting in (...) (21 years ago, 7-Jan-05, to lugnet.robotics.rcx.robolab)
|
| |
| | Re: LEGO new crane: a step in the right direction?
|
|
I hope the steering is there (and it is as it should be, operated by the steering wheel, and not the exclusive headlight on top). (21 years ago, 6-Jan-05, to lugnet.technic, FTX)
|
| |
| | Re: NEW Brick Testament book: The Ten Commandments
|
|
(...) Brendan, Each book gets better--the covers, the composition, and the feel of the contents. I trust these are bringing you much success and not a little pecuniary benefit; it's marvelous to see these doing so well. Neat! best LFB (21 years ago, 7-Jan-05, to lugnet.books, FTX)
|
| |
| | Re: Call for Nominations: 2005 LDraw.org Steering Committee
|
|
(...) I second the nomination. -Tim (21 years ago, 7-Jan-05, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Construction project
|
|
I have been busy the last few months looking for a job and haven't been able to put any new pics of my construction site on the net. I now have a drafting job at a company that makes screeners, pulverizers, conveyors, and rock crushers). This is the (...) (21 years ago, 7-Jan-05, to lugnet.technic)
|
| |
| | Re: Call for Nominations: 2005 LDraw.org Steering Committee
|
|
(...) I, Ross Crawford, nominate Philippe Hurbain (21 years ago, 7-Jan-05, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Re: Call for Nominations: 2005 LDraw.org Steering Committee
|
|
(...) I, Ross Crawford, nominate Steve Bliss (21 years ago, 7-Jan-05, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | RCX Sensor Port
|
|
I've been looking into the interface of the RCX sensor port, as well as studying available information. This page from Stef Mientki suggests that the port uses a current source: (URL) believe this to be correct. According to the circuit topology and (...) (21 years ago, 7-Jan-05, to lugnet.robotics)
|
| |
| | LNPd keeps sending TX_FAILURE
|
|
I'm running LNPd on Gentoo Linux 2.6.7. Everything seems to work fine except transmitting messages to the RCX. The lnptest application that comes with LNPd keeps reporting a Collision every time it tries to transmit something. It does however (...) (21 years ago, 7-Jan-05, to lugnet.robotics.rcx.legos, FTX)
|
| |
| | Re: Call for Nominations: 2005 LDraw.org Steering Committee
|
|
(...) I second the nomination of Chris Dee ROSCO (21 years ago, 7-Jan-05, to lugnet.cad.dev.org.ldraw, FTX)
|
