|
|
 | | Re: 16 digital outputs as Fred suggested
|
| 1. please read the Appendix B documentation in (URL) explains this in more detail than the FAQ. 2. you must the even-numbered Yx signals for output latches. Since Y6 is taken (by the on-board latch for the motor drivers), you're left with Y0, Y2, (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
| | | | | Re: Help - Cannot download!
|
| try using DL.EXE (part of the Interactive C distribution) after following the serial port options directions given the FAQ (under downloading problems). fred In your message you said: (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
| | | | | Vector V2x Compass
|
| Hello: I have a V2x compass and I was trying to hook it into my handyboard using Tom Brusehaver's .icb, .c and instructions as described in the contributed section. I have also grounded the M/S pin on the compass. The EOC pin is sent to the HB thru (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
| | | | | Analog Encoders
|
| Hi, when I compile fencdr0.asm, I get "xxxjunk.c"(68): Warning --- Value Truncated "xxxjunk.c"(70): Warning --- Value Truncated "xxxjunk.c"(68): Warning --- Value Truncated "xxxjunk.c"(70): Warning --- Value Truncated Does everyone else get this (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
| | | | | >1A adapter?
|
| Hello folks, I am currently using the HB to control a robot tethered to a PC (via the serial/charger board), as I'm using genetic algorithms to evolve controllers. The robot pulls about an amp (with motors, servo, sonar etc.), and I'm running it off (...) (26 years ago, 12-Apr-98, to lugnet.robotics.handyboard)
|
|
