 | | Sharp GP2D02
|
|
I purchased two Sharp GP2D02 infrared sensors from Acroname and downloaded their interface to a Handy Board and Barry Brouilette's interface to the Handy Board. I was wondering which any of you have used and why so I can select one to use on in my (...) (26 years ago, 25-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | multi-device output controller
|
|
I've been considering various ways to control more than three output devices with only the three ports and came up with the following idea. I don't have the electrical design knowledge to implement, so if this idea sounds good, I'd like to (...) (26 years ago, 25-Mar-99, to lugnet.robotics)
|
| |
| | Re: people i would most like to build with...
|
|
Scott, Wow, I work there! (consultant for the University), but commute from Detroit's eastern suburbs (57 miles). There are a few other LEGO maniacs in the Detroit/Ann Arbor area, and then there is Larry Pieniazek, who lives in Ada Michigan. The (...) (26 years ago, 25-Mar-99, to lugnet.cad, lugnet.build)
|
| |
| | RE: FORTH editor/IDE
|
|
(...) I'm not in the process of writing an IDE, but I'm not sure you need one either. (...) I'm going to make the pbFORTH a bit more user friendly shortly, by adding a MARKER word that essentially clears out all of your own definitions. (...) The (...) (26 years ago, 25-Mar-99, to lugnet.robotics.rcx.pbforth)
|
| |
| | Re: 3-wire converter for homebrew sensors
|
|
(...) It is a heck of a lot of complexity for a little added linearity. If you look at the plots on my general purpose interface section; the simple resistor interface is pretty linear. I think most of the nonlinearity in the powered version is due (...) (26 years ago, 25-Mar-99, to lugnet.robotics)
|
