 | | Re: how...RCX talk to each other?
|
|
Finally, a question I can answer! To transmit a message to another RCX, use the Green Commands block, "Send to RCX." To program behavior on the receiving RCX, use the Blue Sensor Watcher, "RCX." The messages are simple 8-bit numbers (from 0 to 255), (...) (26 years ago, 1-Apr-00, to lugnet.robotics)
|
| |
| | Re: controling two motors with only one output?
|
|
(...) Or you can just build one of the following devices and save allot of time and effort. (URL) the Motor/Light Block or the (MS)2 Expander Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 1-Apr-00, to lugnet.robotics.rcx)
|
| |
| | Re: NQC on Linux dilema...
|
|
(...) OK, here it goes: (I am in root) Output_Start: Downloading program: Tx: 55 ff 00 10 ef 10 ef Rx: 55 ff 00 10 ef 10 10 ef 55 Tx: 55 ff 00 10 ef 10 ef Rx: ff 00 ef 10 ef 10 ff ae ed 00 10 ef 10 ef 55 ff 00 ef 10 ef 10 Tx: 55 ff 00 50 af 50 af (...) (26 years ago, 1-Apr-00, to lugnet.robotics.rcx.nqc)
|
| |
| | Type-5 conditional edge line
|
|
I have a question about the type-5 conditional line. Assume I have four points in 3d space like this: (If you're reading LUGNET via the web interface, you must push "view raw message" to see my ASCII art.) 1---2 | | | | | | 4---3 Except that the (...) (26 years ago, 1-Apr-00, to lugnet.cad.dev)
|
| |
| | Re: International Box Update
|
|
(...) Sounds like a plan. Is just JA enough euro exposure? I'm OK either way (...) (26 years ago, 1-Apr-00, to lugnet.market.jambalaya)
|
