 | | Re: Motorizing 9V switch points (translation from french) —David Koudys
| | | | (...) Well, like many others, I was completely inspired by this site. I built a controller, put it on my layout and loved it. The only issue I had was that the smallest 9V controller was still too big for one part of my layout--the larger cars and (...) (20 years ago, 14-Dec-03, to lugnet.trains, FTX)
| | | | | | | | | | Spending too much time on redesign :) Was Re: Motorizing 9V switch points (translation from french) —David Koudys
| | | | | In lugnet.trains, David Koudys wrote: snip (...) Worked on it a bit today... Just reducing the height of the building--the best I can do is 6 bricks 2 plates high. Move the motor/eccentric assembly down a few plates and take the 5 stud axle out of (...) (20 years ago, 14-Dec-03, to lugnet.trains, FTX)
| | | | | | | | | | | | Re: Spending too much time on redesign :) Was Re: Motorizing 9V switch points (translation from french) —Philippe Label
| | | | | In lugnet.trains, David Koudys wrote: ... (...) ... (...) Hi Dave, This is funny, I went to the same kind of problem and also tried to reduce the width of the block very recently. Are we telepathic ? However, I started from Ed McGlynn's most recent (...) (20 years ago, 14-Dec-03, to lugnet.trains, FTX)
| | | | | | |
