 | | Mechanical tricks —Rick Clark
|
| | | Hello, I'm looking for a mechanical (non-robotic) solution to a technic problem I'm facing. (I crossposted to robotics, cause you guys think about gears all the time, too. Plus, you're really smart and stuff.) My input is a constantly rotating (...) (23 years ago, 2-Nov-01, to lugnet.technic, lugnet.robotics)
|
| | | |
| | | | | Re: Mechanical tricks —Trevyn Watson
|
| | | | | Try driving a gear off-center (ie put the drive axle of the motor into one of the other holes in the gear). This may not give you exactly the behaviour you want though. (...) (23 years ago, 2-Nov-01, to lugnet.technic, lugnet.robotics)
|
| | | | | |
| | | | | | | Re: Mechanical tricks —Jonathan Brown
|
| | | | | | Rick There's a couple of ways you can do this. The easy and compact way (if you're a grinder) is to cut the teeth off one half of the circumference of the drive gear -- works pretty well. If you want an intermittent motion (although it's not a full (...) (23 years ago, 2-Nov-01, to lugnet.technic, lugnet.robotics)
|
| | | | | | |
| | | | | Re: Mechanical tricks —John Barnes
|
| | | | I happened upon a similar requirement some time back and discovered that (Technica ref (URL) gears - Knob wheel 32072 are able to "mesh" like gears (ie rotating in the same plane) providing an intermittent drive. These parts have shown up in a (...) (23 years ago, 2-Nov-01, to lugnet.technic, lugnet.robotics)
|
| | | | |
