|
|
 | | Re: *** MLCad V3.40 ***
| Michael Horvath
| (...) Apparently the problem still exists. It makes editing Datsville more difficult at times. Mike H (1 year ago, 8-Jan-12, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Cristian Sala
| Thanks, Michael. Very much appreciated. Cristian www.brickinitalia.org (1 year ago, 1-Jan-12, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Lars C. Hassing
| (...) To err is human, to undo is divine ;-) Thanks, Happy New Year /Lars (1 year ago, 31-Dec-11, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Michael Horvath
| (...) I haven't installed the program yet to check... But in the previous version there was a problem when referencing a MPD file from inside another LDR or MPD file. I mean, let's say you have CAR.LDR and it references WINDSHIELD.MPD. Then, the (...) (1 year ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Mike Gallagher
| (...) Undo Joy! thanks again Michael! Mike (1 year ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Timothy Gould
| (...) Thanks, Michael. Very much appreciated. Tim (1 year ago, 29-Dec-11, to lugnet.cad.mlcad)
| | | | | Re: *** MLCad V3.40 ***
| Philippe Hurbain
| Hello Michael, Highly appreciated (especially the undo!!!), a nice X-mas present for LDraw community. One small problem, in position/orientation dialog it seems that I can't check "Use rotation vector value"? Any hint? Philo (1 year ago, 28-Dec-11, to lugnet.cad.mlcad)
| | | | | *** MLCad V3.40 ***
| Michael Lachmann
| Hello all, I would like to announce that there is a new version of MLCad available! MLCad V3.40 What's new: - Implemented basic undo functionality (might be a bit slow, but should work) - Improvements for network installation or installation under (...) (1 year ago, 27-Dec-11, to lugnet.cad.mlcad) !
| | | | | Re: MLCad rotaton point?
| David Laswell
| (...) Okay, in MLCad (and possibly other LDraw GUIs), an individual part will rotate around its origin point. On any standard brick/plate/tile, this origin point is typically found in the exact center of the top surface, excluding any studs. So if (...) (2 years ago, 2-Oct-11, to lugnet.cad.mlcad)
| | | | | Re: MLCad rotaton point?
| Willy Tschager
| (...) (URL) (2 years ago, 3-Sep-11, to lugnet.cad.mlcad)
|
|
