|
In lugnet.cad.dat.parts, Orion Pobursky wrote:
> In lugnet.cad.dat.parts, Paul Easter wrote:
> > This part is on the Part Tracker;
> >
> > http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/32278.dat
> >
> > The 32278 I have has a thickness of .0309" which is approximately 19.77LDU. Why
> > are several of these liftarms getting changed to 18LDU?
> >
> >
> > Paul
>
> I've measured these and several others have as well and we all got 18 LDU
>
> -Orion
What are you using to measure with?
I use a dial caliper.
Paul
|
|
|
Paul Easter wrote:
> In lugnet.cad.dat.parts, Orion Pobursky wrote:
> > In lugnet.cad.dat.parts, Paul Easter wrote:
> > > This part is on the Part Tracker;
> > >
> > > http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/32278.dat
> > >
> > > The 32278 I have has a thickness of .0309" which is approximately
> > > 19.77LDU. Why are several of these liftarms getting changed to
> > > 18LDU?
> > >
> > >
> > > Paul
> >
> > I've measured these and several others have as well and we all got
> > 18 LDU
> >
> > -Orion
>
> What are you using to measure with?
>
> I use a dial caliper.
>
> Paul
I confirm Pauls measurement. I compared it with a brick and it has
the same thickness. This is also needed to connect a pin with the holes.
CU Bernd
|
|
|