To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.build.schleimOpen lugnet.build.schleim in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Building / Schleim / 234
233  |  235
Subject: 
Re: A french BB 62400
Newsgroups: 
lugnet.build.schleim, lugnet.trains
Date: 
Wed, 1 Jun 2005 16:02:25 GMT
Viewed: 
3474 times
  
In lugnet.build.schleim, Didier Enjary wrote:
   In lugnet.build.schleim, Jason J. Railton wrote:
   In lugnet.trains, Didier Enjary wrote:
   3. The top can not be fitted with a plate but is perfectly fitted by a 1x2 tile which does not have a tube. The tile is slightly sliped on the side which represent an offset technique (undocumented AFAIK)

This is a useful technique I and others have used before, but in this case it isn’t actually necessary. Try putting a technic 1x1 brick with a half pin in it, or a ‘dalek’ brick (1x1 brick with studs on all sides) on top of the laid-down headlight brick. You’ll find you can fit an ordinary 1x2 plate to the side, perfectly fitting over the two studs.

The only reason for using a tile here is to get the smooth surface. You can just as easily fit a 1x4 tile or larger, which do have tubes.

Jason Railton

I’m not sure but I think there’s a misunderstanding there. (I’ve been not precise enough)

There are two tiles and if the one in the side (SNOT mounted) of the engine has no offset, the one “stud up” has a 0.4 stud offset relatively to the clear brick. (from the picture, i’m not able to read the ldr file) which prevent from using a plate (or in other words, this building is possible thanks to non-tubed tiles).

Didier

Right, I can see it now. It’s the tile on top that’s offset a little because the stud it’s on (the transparent brick) isn’t in a natural position.

Of course, it would probably have been simpler to use two clear 1x2 plates with a tile on top, and mount the whole lot on its side. That would give you a taller window, too.

Jason R



Message is in Reply To:
  Re: A french BB 62400
 
(...) I'm not sure but I think there's a misunderstanding there. (I've been not precise enough) There are two tiles and if the one in the side (SNOT mounted) of the engine has no offset, the one "stud up" has a 0.4 stud offset relatively to the (...) (19 years ago, 1-Jun-05, to lugnet.build.schleim, lugnet.trains, FTX)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR